This hood is hand laid fiberglass and uses stock hardware for easy of installation. Included is a black metal honey comb vent grille and two silver "ram air" decals. Hood works with both gas and diesel engines.
Has the ram air cutout on hoods underside for both intake locations. Comes with a block off plate for the side you will want to close off on the underside. Replace your stock hood with a more stylish functional ram air hood.
Besides the added cool looks, they have cool function in directing outside air to your air filter increasing performance! Made in the U S A! By one of the very best! We do not sell cheap low end hoods! Or headaches you could call them!Over the years we have dealt with many manufactures & weeded out the bad ones. We have seen and heard it all. Nobody likes a headache & were not going to sell you one! It is constructed from hand-laid fiberglass and high quality "ISO" resin. Comes Gel Coated Gray ready to prep, prime and paint. Made in USA Material: Fiberglass. HOOD CONSTRUCTION; Many of our ram air hoods are constructed of hand-laid fiberglass, using high quality "ISO resin" to give you the best possible quality in a fiberglass hood. It comes with a smooth gel-coat finish, on both top and underside surfaces. All hinge and latch mountings are reinforced with steel plates. All bolt holes are pre-drilled and tapped for easy installation.
To install these hoods, all you need to do is transfer your stock hardware onto it and bolt it on to the factory hinges for final alignment. ISO resins are a higher quality, low shrink resin that allows the part to withstand more heat and prevent distortion.Frequently Asked Questions Q 1: Will water get into my intake with your ram air hood? Our hoods have a built-in water management system to prevent water from getting in. To date, we have not had a complaint of water getting into an intake.
Q 2: What should I do if your product comes damaged? It is expressly recommended that the package be opened and inspected immediately upon receipt, even if the box looks undamaged.
If you or someone else signs off on a damaged product, we will not be held responsible. Q 4: Should I prefit your products before I have them painted? Yes, it is highly recommended that any hood be prefit before it is painted. This is especially true with fiberglass parts.
If you are not the original owner it is possible that the vehicle was in a previous accident, which could effect how our product fits you vehicle. Even new vehicles are not all assembled exactly the same.
Sometimes you have to readjust your fenders and do other minor adjustments to make everything right. WARNING CA Proposition 65: Yes. The item "Ford F250/350/450/550 Super Duty Power Hood Functional Ram Air Hood Fits 2011-16" is in sale since Friday, March 4, 2016. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Hoods".
The seller is "brodydogautoparts" and is located in Woonsocket, South Dakota. This item can be shipped to United States.